水解-接触氧化工艺处理针织染整废水

介绍了采用水解-接触氧化工艺处理针织染整废水,工程运行结果表明：CODcr和色度的去除率分别达到91.3%、88%,最终排放污水达到国家污水Ⅰ级标准.该工艺具有处理效果好、经济、运行稳定等特点,在染整废水处理中具有实用性.     

炼油污水的深度处理

对炼油污水深度处理常用技术——过滤、膜分离、化学氧化技术进行了详细的论述，并结合中试试验，对动态砂滤系统、PAN膜处理系统和高级氧化系统处理炼油厂二级排放水的适用性进行了论证。     

气浮+生物接触氧化工艺处理食品加工废水

通过气浮 生物接触氧化工艺处理速冻食品加工废水的实验、设计和工程运行,结果表明:废水COD去除率能达到97%以上,使得最终出水的COD＜100mg/l.该工艺对冲击负荷有较强的适应性.     

多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

DRY AND WET WEATHER FLOW NUTRIENT LOADS FROM A LOS ANGELES WATERSHED1

Effective watershed management requires an accurate assessment of the pollutant loads from the associated point and nonpoint sources. The importance of wet weather flow (WWF) pollutant loads is well known, but in semi‐arid regions where urbanization is significant the pollutant load in dry weather flow (DWF) may also be important. This research compares the relative contributions of potential contaminants discharged in DWF and WWF from the Ballona Creek Watershed in Los Angeles, California. Models to predict DWF and WWF loads of total suspended solids, biochemical oxygen demand, nitrate‐nitrogen, nitrite‐nitrogen, ammonia‐nitrogen, total Kjeldahl nitrogen, and total phosphorus from the Ballona Creek Watershed for six water years dating from 1991 to 1996 were developed. The contaminants studied were selected based on data availability and their potential importance in the degradation of Ballona Creek and Santa Monica Bay beneficial uses. Wet weather flow was found to contribute approximately 75 percent to 90 percent of the total annual flow volume discharged by the Ballona Creek Watershed. Pollutant loads are also predominantly due to WWF, but during the dry season, DWF is a more significant contributor. Wet weather flow accounts for 67 to 98 percent of the annual load of the constituents studied. During the dry season, however, the portion attributable to DWF increases to greater than 40 percent for all constituents except biochemical oxygen demand and total suspended solids. When individual catchments within the watershed are considered, the DWF pollutant load from the largest catchment is similar to the WWF pollutant load in two other major catchments. This research indicates WWF is the most significant source of nonpoint source pollution load on an annual basis, but management of the effects of the nonpoint source pollutant load should consider the seasonal importance of DWF.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

电催化氧化处理除草剂异噁草酮废水的效能

为有效处理含异噁草酮除草剂废水，以Sb掺杂Ti／SnO2电极为阳极，不锈钢板为阴极，采用电催化氧化技术对异噁草酮废水进行降解，研究了不同影响因素对异噁草酮去除率的影响，并分析了异噁草酮的降解效果。结果表明，当异噁草酮初始浓度为100mg／L、电流密度为20mA／cm2、电解质投加量为0．10mol／L，反应120min后，异噁草酮去除率达到94％，此时TOC去除率为57．9％，能耗为25kWh／m2，且废水的可生化性能显著提高。     

Mn/γ-Al2O3催化剂的制备及头孢合成废水的催化臭氧氧化法深度处理

对Mn/γ-Al₂O₃催化剂的制备条件及头孢合成废水的催化臭氧氧化法深度处理工艺条件进行了优化。实验结果表明：以Mn（NO₃）₂溶液为浸渍液，Mn/γ-Al₂O₃催化剂的最优制备条件为浸渍液浓度0.10 mol/L、浸渍时间9 h、焙烧温度400 ℃、焙烧时间2 h;在反应时间为30 min、废水pH为9.0、臭氧通量为4.6 mg/min、催化剂加入量为5 g/L的条件下，当进水COD、BOD₅、ρ（氨氮）和色度分别为220~250 mg/L，8~10 mg/L，10~12 mg/L和60~70倍时，出水COD、BOD₅、ρ（氨氮）和色度的平均去除率分别为53%，30%，33%和93%，出水水质满足GB 21904—2008《化学合成类制药工业水污染物排放标准》的要求。     

竹制填料生物接触氧化工艺处理污染河水简

针对受污染的湖溪河水质特征，以传统弹性塑料填料做对比，研究以竹球和竹丝为填料的生物接触氧化工艺，考察填料的挂膜时间、生物量和污水处理效果；确定连续曝气和间歇曝气时反应器的最优运行工况：连续曝气时为HRT=7.5 h，DO=3 mg/L；间歇曝气时为厌氧1.2 h、好氧6.3 h交替运行。实验结果表明，与弹性塑料填料相比，竹制填料挂膜速度快，竹球填料的水处理效果最好；连续曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别为66.7%、47.9%、57.1%和30.6%；间歇曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别64.08%、39.95%、60.7%和54.68%；竹制填料可替代传统的塑料填料作为生物接触氧化工艺的载体填料。